nodeLynk I2C devices communicate 5V I2C data and provides 5V DC power through this connector. The nodeLynk I2C Interface uses a standard 4-Pin I2C Input and I2C Output connector. nodeLynk I2C devices allow you to chain together several devices on the I2C bus, and communicate to each device individually at high speed (subject to the limitations of I2C). NCD is the creator of plug and play modular hardware using nodeLynk, which is hardware I2C Interface connector standard. #I2c analog to digital converter windows#Control this 0-10V DAC over the internet using popular cloud computing platforms including Azure and Particle or from Windows and Linux computers. This device is intended for use in applications that may require retrofitting older hardware with modern electronics for IoT interface applications. Interface this 0-10V DAC with Raspberry Pi, Arduino, Onion Omega, Beaglebone, Windows, Particle Photon or any Linux computer using our extensive line of I2C adapters (see the compatibility tab for links).Īpplications for this I2C 0-10V DAC mini module include sensor calibration, valve controllers, sprinklers, light fixture controllers, data acquisition and much more. This 0-10V DAC supports three modes: standard 100kbps, fast 400kbps and high speed 3.4Mbps. If your application requires more than two of these controllers, consider using a i2c multiplexer controller, which allows you to connect multiple 0-10V DACs with one I2C master device. This 0-10V Digital to Analog converter board comes with I2C address jumper for changing the I2C address, allowing two 0-10V DAC controllers to share the same I2C bus. The 0-10V output is programmable with 12-bit resolution, allowing 4,096 possible output voltages across the span of 0-10V ☑%. This power booster and signal amplifier takes 0-5V from the DAC and converts into 0-10V DAC signal. This device uses the MCP4725 I2C DAC equipped with on-board power boost circuit and a rail-to-rail signal amplifier. This mini module comes with I2C communications so you can interface with all major micro controllers with I2C communications. This One Channel 0-10V I2C Digital to Analog converter is also known as 0-10V DAC or 0-10V voltage output. If you are looking for a 0-10V digital to analog DAC board then look no further. There is a large number of devices and equipment which are controlled using voltage variation that require a 0-10V signal. Digital to analog conversion devices play a major role in data acquisition.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |